employee
Komsomolsk-upon-Amur, Khabarovsk, Russian Federation
employee
Komsomolsk-on-Amur, Khabarovsk, Russian Federation
employee
Komsomolsk-on-Amur, Khabarovsk, Russian Federation
UDC 621.9
Russian Library and Bibliographic Classification 345
The papder objective is to find the rational parameters of the cutting mode with a special SKIF-M interlocking side mill for superhard (HRC 65 and more) surfaces. The study results are the following: the rationality of using an interlocking side mill in comparison with monolithic carbide end mills is shown, the area of rational parameters of the cutting mode with this mill is given. It is found that the most rational use of a mill is at a cutting speed of 50 m/min, a cutting depth of 2 mm and a feed per milling tooth of 0.05 mm. It is shown that an increase in cutting speed, cutting depth, or feed to the tooth is irrational. Conclusions: 1. The objective is achieved by experimentally examining the mill's operability for a wear resistance period of 0.5 mm under different operating conditions. 2. It is found out that with increasing cutting depth, the durability period decreases significantly and becomes critical at a cutting depth of 3 mm. The novelty of the work: the areas of rational use of a special SKIF-M mill for treating surfaces of HRC 65 and more are established.
: surfaces, treatment, operation, mill, parts, research, cutting
1. Mokritsky BYa, Skripilyov AA. Control of milling of high-hardness workpieces. Vestnik Mashinostroeniya. 2022;12:72-75. DOI:https://doi.org/10.36652/0042-4633-2022-12-72-75.
2. Mokritskiy BYa, Mokritskaya EB. Blade processing of hardened materials. Processing of workpieces hardened by high-hardness surfacing. Strengthening Technologies and Coatings. 2021;17(11):495-497. Doi:https://doi.org/10.36652/1813-1336-2021-17-11-495-497.
3. Kirichek AV, Lazutkin AG, Solovyov DL. Static and pulse processing and equipment for its implementation. STIN. 1999;6:20-24.
4. Vereshchaka AA, Vereshchaka AS, Grigoriev SN. Multilayer composite nano-structured coatings of cutting tools operating in harsh conditions. Strengthening Technologies and Coatings. 2012;12:3-11.
5. Promptov AI, Livshits OP, Zamashchikov YuI, Makarov RV. Recommendations on selecting cutting modes for finishing operations of turning, boring, and end milling with a tool equipped with a hard alloy, ceramics, and composite: textbook. Irkutsk: Publishing house of IrGTU; 2000.
6. Deederich N. Metallisher zwischeushichten im bereich der aufbanschneidesbildung. Ind. -Anz.1968;90(24)457-460.
7. Fuch M, Scheffer M. Ab initio pseudopotentieals for electronic structure calgulations of polu-atomic sustems using density-finctional theory. Comp. Phys. Commun. 1999;119:67-11.
8. Schneider IM. Effect of transition metal additives on electronic structure and elastic properties of TiAl and Ti3Al. Phys. Rev. B 74, 174110, 2006.
