Krasnodar, Krasnodar, Russian Federation
The technical solutions for efficiency increase of technological systems for parts finishing and strengthening based on the use of screw containers are offered. The essence is revealed, design peculiarities and technological possibilities of a rotor-helical technological system with a vibrocontainer and an adjusting spring and a rotor-helical technological system with a rotating container are described. The results of experi-mental researches of granular material motion in a screw container with the use of three-factor experiment planning are shown. The assessment of the screw containers efficiency application reasoning from their design peculiarities is given.
technological system, screw container, vibratory activator, extension spring, finishing, strengthening, load mass
1. Pat. 2430825 RF, IPC В24В 31/06. Device for Finishing-Trimming / Belokur К.А., Serga G.V.; Applicant and Patent Holder Kuban State Agricultural University. - № 2009144621/02; Applic. 01.12.09; published. 10.10.11, Bull.Бюл. № 28.
2. Pat. 2507053 RF, IPC В24В 31/02. Device for Finishing-Trimming / Serga G.V., Lebedev V.А., Ivanov V.V.; Applicant and Patent Holder Kuban State Agricultural University -№ 2012150229/02; applic. 23.11.12; published. 20.02.14, Bull. № 5.
3. Pat. 2519398 RF, IPC В24В 31/02. Machine for Chemical Finishing Strengthening of Parts / Serga G.V., Ivanov V.V., Lebedev V.А.; Applicant and Patent Holder Kuban State Agricultural University. - № 2013106597/02; Application 14.02.13; pub-lished. 10.06.14, Bull. № 16.
4. Lebedev, В.А. Intensification of Finishing Strengthening in Screw Drums by Successive Compression and Rarefaction of Load Mass / V.А. Lebedev, N.N. Kuznetsova, G.V. Serga // Inter-College Scientific Proceedings/ Don State Technical University. - Rostov-upon-Don: Publishing Center of DSTU, 2013. - pp. 214-231.
