One of the most problem areas in the technological process of cog-wheel machining is a succession of roughing (by a hob) and finishing (by shaving). In the paper there are shown the results of comparative experimental researches of a succession heredity “milling by a hob –shaving) at working with an uncorrelated and correlated shaver. The shaver correction was carried out according to the results of the analysis of toothing and accuracy parameters (profile error) of a milling wheel.
hob, shaver, cog-wheel, machining accuracy, profile correction.
1. Modern Methods of Cog-wheel Machining / А.S. Ka-lashnikov, Yu.А. Morgunov, P.А. Kalashnikov. М.: Publishing Center “Spectrum”, - 2012. - pp. 239.
2. Klepikov V.V., Taratynov О.V., Kurochkin N.А., Solonitsyn B.М. Analysis of quality formation in involute surfaces of spur gears // Bulletin of Mechanical Engineering. - 2005. - № 3. - pp. 49-53.
3. Cherepakhin А.А, Klepikov V.V., Soldatov V.V. Me-thods of Critical Parts Working for Motor Cars. М.: MSIU, 2011. - pp. 214.
4. Parametric Optimization of Cog-Wheel Machining. Monograph: Cherepakhin А.А., Vinogradov V.М., Klepikov V.V./ Deutschland, Saarbrucken, the publishing house LAP Lambert Academic Publishing GmbH &Co., 2012 г. - 230
5. Taratynov О.V, Klepikov V.V., Cherepakhin А.А. Ways for technological system up-dating // Engineering Techniques. - 2014. - № 9. - pp. 61-63.
6. Klepikov V.V., Cherepakhina А.А. Ways for technological process up-dating in parts finishing // Science Intensive Techniques in Mechanical Engineering. - 2014. - № 12(42). - pp. 15- 18.
