Tula, Tula, Russian Federation
Cited in the reference literature, empirical formula is usually acceptable for standard materials processed. When new materials have to repeat the experiments again. The article presents the analytical relationships derived from the generalization of the work of Russian and American scientists, in particular: VF Bobrov, NI Lvov, VS Kushner, a Merchant ME, Astakhov, V.P. These relationships relate the values of the components of the cutting force with time and the actual yield strength of the material being processed, making it much easier to calculate the components of the experiment of cutting force in turning based on the radius of curvature of the cutting edge and tool wear on the rear surface. Shrinkage factor chips taken approximately equal to one. Experimental verification showed acceptability found dependences for practical use, particularly important in the processing of materials of new brands.
cutting force, analytical definition, tool wear.
1. Bobrov, V.F. Multi-pass Fastening Thread Cutting with Cutter. - М.: Methanical Engineering, 1982. - pp. 104.
2. Yamnikov, А.S., Yamnikova, О.А. Investigation of power parameters of thread cutting process with ceramic plated cutters // Promising Techniques and Systems of Me-chanical Engineering. Donetsk. - 2016. - № 1. - pp. 151-157.
3. Yamnikov, А.S., Chuprikov, А.О., Kharkov, А.I. Chip thickening at high-strength steel turning // Proceedings of Tula State University. Engineering Sciences. - 2016. - № 8. Part 1 - pp. 194-201.
4. Yamnikov, А.S., Chuprikov, А.О., Kharkov, А.I. Tool Life Increase at Reinforced Thrust Thread Cutting in High-Strength Blanks // STIN. - 2015. - №6. - pp. 17-21.
5. A.S. Yamnikov, A.O. Chuprikov and A.I. Khar’kov. Extending Tool Life in Buttress-Thread Cutting on High-Strength Blanks / ISSN 1068-798X, Russian Engineering Research, 2015, Vol. 35, No. 12, pp. 953-956.
6. Kushnir, V.S. Thermo-mechanical Theory of Ductile Materials Continuous Cutting: monograph. - Irkutsk. Publishing House of Irkutsk University, 1982. - pp. 180.
7. Astakhov V.P. Authentication of FEM in metal cutting. Chapter 1 in book Finite Element Method in Manufacturing Processes. J.P. Davim, Ed., New York: Wiley, 2011, P. 1-43.
8. Yamnikov, А.S., Myagkov, Yu.V. Definition of mini-mum specific normal force essential for cutting beginning // College Proceedings. - М.: Mechanical Engineering, 1979. № 12. - pp. 111- 115.
9. Lvov, N.P. Definition of minimum-possible thickness of layer cut // Machines and Tools. - 1969. - № 4. - pp. 21-33.
10. Bezukhov, N.I. Fundamentals of Theory of Elasticity, Plasticity and Creep. - М.: Higher School Publishing House, 1961. - pp. 532.
