Submit manuscript
Home / Journals / Modeling of systems and processes / Volume 12 Issue 4 / ANALYSIS OF RISC PROCESSOR BLOCK DESIGN WITH REGARD TO FAULT TOLERANCE
ANALYSIS OF RISC PROCESSOR BLOCK DESIGN WITH REGARD TO FAULT TOLERANCE
Submit manuscript
To cite
Citations:

ANALYSIS OF RISC PROCESSOR BLOCK DESIGN WITH REGARD TO FAULT TOLERANCE
UDK 62 Инженерное дело. Техника в целом. Транспорт
Zolnikov V. 1
Yagodkin A. Sergeevich 2
Antsiferova V. 3
Evdokimova Svetlana Anatol'evna 4
Skvortsova Tatyana Vladimirovna 5
Yankov A. Il'ich 6
Authors:
1.  Voronezh State University of Forestry and Technologies named after G.F. Morozov

Russian Federation
2.  Voronezh State University of Forestry and Technologies named after G.F. Morozov

Russian Federation
3.  Voronezh State University of Forestry and Technologies named after G.F. Morozov

Russian Federation
4.  Voronezh State University of Forestry and Technologies named after G.F. Morozov

Voronezh, Russian Federation
5.  Voronezh State University of Forestry and Technologies named after G.F. Morozov

Russian Federation
6.  LLC «SPE Detector»

Russian Federation
Type:
Article
DOI:
https://doi.org/10.12737/2219-0767-2020-12-4-56-65
Pages:
from 56 to 65
Status:
Published
Received:
23.01.2020
Accepted:
23.01.2020
Published:
23.01.2020
Subject area:
UDK 62 Инженерное дело. Техника в целом. Транспорт
Language:
Russian
Keywords:
RISC processor, integrated circuits, 1890vm2t chip, multiplication-division module, fault tolerance
Abstract and keywords
Abstract (English):
The article is devoted to the analysis of RISC-processor blocks for fault tolerance, which was carried out on the example of the 1890vm2t processor. the paper describes the block diagram of this processor and the methodology for evaluating the fault tolerance of the multiplication-division module MDUnit. The evaluation of the failure tolerance and the dependences of the values share about the results and formulated requirements to architecture functional blocks.

Keywords:
RISC processor, integrated circuits, 1890vm2t chip, multiplication-division module, fault tolerance
References

1. Zol'nikov, K. V. Sovremennoe proektirovanie elektronnoy komponentnoy bazy / K. V. Zol'nikov, V. V. Lavlinskiy // Ekonomika. Innovacii. Upravlenie kachestvom. - 2015. - № 1 (10). - S. 40-41.

2. Shemotehnicheskiy bazis i proverka mikroshem na rabotosposobnost' / V. K. Zol'nikov, S. A. Evdokimova, A. V. Fomichev, V. N. Chikin, A. V. Achkasov, V. F. Zinchenko // Modelirovanie sistem i processov. - 2018. - T. 11, № 4. - S. 25-30.

3. Smerek, V. K. Model' fizicheskih processov v elementah SBIS pri vozdeystvii tyazhelyh zaryazhennyh chastic / V. K. Smerek, V. K. Zol'nikov, K. I. Tapero // Modelirovanie sistem i processov. - 2010. - № 1-2. - S. 41-48.

4. Zol'nikov, V. K. Metodika proektirovaniya radiacionno-stoykih integral'nyh shem / V. K. Zol'nikov, V. N. Achkasov, V. P. Kryukov // Voprosy atomnoy nauki i tehniki. Seriya: Fizika radiacionnogo vozdeystviya na radioelektronnuyu apparaturu. - 2004. - № 1-2. - S. 57-60.

5. Obobschennaya metodika proektirovaniya tehnicheskih blokov vysokonadezhnyh programmno-tehnicheskih kompleksov special'nogo naznacheniya / V. K. Zol'nikov, D. M. Utkin, S. A. Evdokimova, V. I. Anciferova // Radiacionnaya stoykost' elektronnyh sistem «Stoykost'-2014» : sbornik tezisov dokladov 17-y Vserossiyskoy nauchno-prakticheskoy konferencii po radiacionnoy stoykosti elektronnyh sistem. - M. : Nacional'nyy issledovatel'skiy yadernyy universitet «MIFI», 2014. - S. 71-72.

6. Metody obespecheniya stoykosti mikroshem k odinochnym sobytiyam pri proektirovanii radiacionno-stoykih mikroshem / V. N. Achkasov, V. A. Smerek, D. M. Utkin, V. K. Zol'nikov // Problemy razrabotki perspektivnyh mikro- i nanoelektronnyh sistem (MES). - 2012. - № 1. - S. 634-637.

7. Algoritmicheskaya osnova modelirovaniya i obespecheniya zaschity tipovyh KMOP elementov v processe proektirovaniya / V. K. Zol'nikov, V. A. Smerek, V. I. Anciferova, S. A. Evdokimova // Modelirovanie sistem i processov. - 2013. - № 3. - S. 14-16.

8. Smerek, V. A. Ocenka sboeustoychivosti integral'nyh shem ot vozdeystviya tyazhelyh zaryazhennyh chastic v cifrovyh mikroshemah na stadii proektirovaniya / V. A. Smerek, D. M. Utkin, V. P. Kryukov // Modelirovanie sistem i processov. - 2011. - № 4. - S. 71-75.

9. Kononov, V. S. Osobennosti proektirovaniya mnogorazryadnyh KMOP-KNI-ACP dlya sozdaniya mnogokanal'nyh vysokoskorostnyh sistem COS s povyshennoy sboeustoychivost'yu / V. S. Kononov // Modelirovanie sistem i processov. - 2019. - T. 12, № 3. - S. 59-64.

10. Modelirovanie ionizacionnyh effektov i effektov smescheniya v cifrovyh mikroshemah dlya SAPR / V. K. Zol'nikov, V. V. Lavlinskiy, Yu. A. Chevychelov, Yu. S. Serbulov, V. I. Anciferova, V. N. Achkasov, Yu. G. Tabakov // Lesotehnicheskiy zhurnal. - 2014. - T. 4, № 4 (16). - S. 280-291.

11. Zol'nikov, V. K. Verifikaciya proektov i sozdanie testovyh posledovatel'nostey dlya proektirovaniya mikroshem / V. K. Zol'nikov, S. A. Evdokimova, T. V. Skvorcova // Modelirovanie sistem i processov. - 2019. - T. 12, № 1. - S. 10-16.

12. Model' radiacionnyh effektov vozdeystviya tyazhelyh zaryazhennyh chastic v KMOP-elementah mikroshem / K. V. Zol'nikov, K. I. Tapero, V. A. Smerek, T. P. Belyaeva // Programmnye produkty i sistemy. - 2011. - № 3. - S. 4.

13. Analiticheskiy metod ocenki effektivnosti odnogo sposoba povysheniya sboeustoychivosti mikroprocessornyh sistem / Yu. S. Akinina, Yu. Yu. Gromov, V. K. Zol'nikov, A. Yu. Kulay, S. V. Tyurin, M. A. Hudyakov // Promyshlennye ASU i kontrollery. - 2018. - № 7. - S. 41-48.

14. Zaschita mikroprocessorov ot odinochnyh sboev / V. A. Smerek, V. M. Antimirov, A. Yu. Kulay, A. L. Savchenko // Modelirovanie sistem i processov. - 2018. - T. 11, № 2. - S. 71-77.

© zh-szf.ru
Support Powered by Editorum,  Instructions
Login or Create
* Forgot password?