Tula, Tula, Russian Federation
branch of JSC "KBP" (Policy Advisory Bureau)- "TSKIB SOO" (Central Design and Research Bureau for Sporting and Hunting Weapons (Deputy Chief of Department)
Tula, Tula, Russian Federation
621
The influence of the form error and rough datum surface position on the accuracy of manufacturing parts of reduced rigidity is considered. A sketch diagram of the allocation of technological zones is presented. A new method for allocating technological zones is proposed.
body thin-walled parts, special device, technological zones, modeling of elastic displacements, regression dependencies
1. Chudin V.N. Extraction of sheet box-shaped products. Kuznechno-shtampovochnoe proizvodstvo, 2002, No. 6. pp. 3-8.
2. Malyshev, A.N., Yakovlev, S.S., Bessmertnaya, Yu.V. Extraction of box parts with small angular radii. Izvestiya TulGU. Seriya Tekhnicheskie nauki, 2015, iss. 4, pp. 111- 117.
3. Vasiliev, A.S. Technological inheritance in mechanical engineering. Bulletin of Rybinsk State Aircraft Technological Academy named after P.A. Solovyov, 2017, No. 1 (40), p. 198-202.
4. Averchenkov, V.I., Vasiliev, A.S., Heifets, M.L. Tech-nological heredity in the formation of manufactured parts quality. Science intensive technologies in mechanical engi-neering, 2018, No.10 (88), pp. 27-32.
5. Danilenko, E.A., Yamnikov, A.S. The use of a vertical machining center for processing thin-walled body parts [Izves-tia Tulskogo gosudarstvennogo universiteta, seria: Tekchni-cheskie nauki], 2019, No. 3, pp. 271-276.
6. Danilenko, E.A., Yamnikov, A.S. Increasing the accura-cy of processing thin-walled box-shaped parts, 2021 J. Phys.: Conf. Ser. 1901 012003 // V International scientific conference «Mechanical Science and Technology Update» 16-17 March. 2021. Omsk, Russia. pp. 323-331. DOI:https://doi.org/10.25206/978-5-8149-3246-4-2021-331-342
